Glass Restoration Kit Instructions

What You Need
Eye Protection
Bucket
Spray Bottle
Warm Water

For best results, repeat every 2 years!

1. Apply the Cleaning Paste
Getting Ready
- Put on eye protection and gloves.
- Fill a bucket and spray bottle with warm water.
- Face the pellet side up and dip the applicator sponge in water for 10 seconds.

How to Apply
- Start at the bottom of the glass panel.
- Using medium-to-firm pressure, work in a consistent circular motion.
- Spread the paste evenly and slowly work your way to the top.
- Mist with water from the spray bottle to keep the paste from drying out.

Safety First!
This product may cause skin irritation. Please wear eye protection and gloves.


2. Remove Calcium
- Rinse the panel with water and wipe with a microfibre towel.
- Ensure all stubborn calcium deposits are gone.
- Use a squeegee to remove remaining water.
- Let the panel air-dry completely.

Handy Tip:
Use the supplied applicator to test progress—scrape a small area of paste. If you still see calcium underneath, reapply and continue until fully removed.


3. Apply Glass Protection
- Wipe the entire panel with a second microfibre towel.
- Unpack the nano-coating sachets and apply with a clean wipe.
- Starting from the bottom, move in straight, overlapping strokes.
- Work quickly so the coating doesn’t dry before you’re done.

BONUS TIP:
If soap scum is present on your screen, it can clog the Restoration Pad and reduce its effectiveness. To prevent this, we recommend getting a Glass Scraper Razor ($10 from your local hardware store) and using it on wet glass at a 45° angle to remove the top layer. This step isn't essential, however it will make restoration easier.