How to use Clean Screens
What You Need
Eye Protection
Bucket
Spray Bottle
Warm Water
For best results, repeat every 2 years!
1. Apply the Cleaning Paste
Getting Ready
- Put on eye protection and gloves.
- Fill a bucket and spray bottle with warm water.
- Face the pellet side up and dip the applicator sponge in water for 10 seconds.
How to Apply
- Start at the bottom of the glass panel.
- Using medium-to-firm pressure, work in a consistent circular motion.
- Spread the paste evenly and slowly work your way to the top.
- Mist with water from the spray bottle to keep the paste from drying out.
Safety First!
This product may cause skin irritation. Please wear eye protection and gloves.
2. Remove Calcium
- Rinse the panel with water and wipe with a microfibre towel.
- Ensure all stubborn calcium deposits are gone.
- Use a squeegee to remove remaining water.
- Let the panel air-dry completely.
Handy Tip:
Use the supplied applicator to test progress—scrape a small area of paste. If you still see calcium underneath, reapply and continue until fully removed.
3. Apply Glass Protection
- Wipe the entire panel with a second microfibre towel.
- Unpack the nano-coating sachets and apply with a clean wipe.
- Starting from the bottom, move in straight, overlapping strokes.
- Work quickly so the coating doesn’t dry before you’re done.
3 Basic Steps
1. With a Clean Screens microfibre cloth, mitt or sponge, apply small amounts of the gel covering the entire area of the surface to be cleaned.
2. Leave for 10 minutes.
3. Rinse off the gel with water and see the results.
If necessary, repeat the application.
3 Basic Steps
1. Apply a 3mm thick gel on the mould stain surface.
2. Leave it on the surface for at least 1-2 hours.
3. Rinse it off with water and see the results.
If necessary, repeat the application.
The surface must be clean and free of dirt, dust, and contaminants.
Existing mould should be removed with the Clean Screens “Mould & Mildew Stain Remover.”
Efflorescence can be removed with the Clean Screens “Calcium Dissolver.”
The substrate must be dry before application.
Apply the first coat along the grout joint, wiping excess from tiles and surrounding areas. While still wet, apply the second coat.
Dries within 1–4 hours under normal conditions.
Tile & Grout Pre-Cleaner Instructions
- Spray evenly over the intended tiled surface.
- Wait at least 5 minutes.
- Agitate with a scrubbing brush, broom, or flat‐floor mop.
- Rinse thoroughly with fresh water - Squeegee excess cleaner toward the drain.
Mop up any remaining cleaner before proceeding to the non-slip treatment.
Ultra Grip Tile-Spray Instructions
⚠️ CAUTION: Always test on a small or sample tile first to confirm compatibility.
- Clean the floor thoroughly using the Clean Screens Tile & Grout Pre-Cleaner.
- Spray the Ultra Grip Tile-Spray evenly over the floor tiles.
- Use a microfibre cloth to spread the liquid uniformly. - Allow the product to work for 30–45 minutes without letting the surface dry.
- If any spots dry prematurely, mist with more spray and continue moving the wet cloth. - After 30 minutes, test slip resistance:
- Dry one tile.
- Wet it again and check grip by touch.
- For higher slip resistance, apply more product and allow longer dwell time. - Once the desired slip resistance is reached, neutralise by rinsing the entire floor with water.
- Remove all residue using a squeegee or mop.